Clone A Willy Kit

Make A Perfect Clone Of Your Willy - Great Fun For Couples!!!

Now you can make a 100% identical replica of your willy with the new "Clone A Willy Kit". The material used is completely safe hypoallergenic rubber will not shrink or crack and is exactly the same material as the rubber used currently by Hollywood movies to create lifelike masks with great detail. It comes with a vibrating unit to turn the your homemade willy into a vibrator!

Follow the basic instructions carefully as seen below to create a perfect clone of your penis!

Clone A Willy Instructions

This process will be much easier if you have a partner to help you, they will help you stay aroused as well!!

Step 1 - The Moulding Process

• Take out contents and place on a table making sure you have everything you need before you begin
• Get Aroused!!
• Insert Penis into Tube and mark roughly where the end of the penis ends so that you know how much material to use.
• Cut off the excess tube with a pair of scissors (Make sure you remove your penis first as you are not making a replacement!!)
• Apply duct tape to the cut end to make the tube smooth for when you insert your penis for cloning.
• Measure 1 and 3/4 cups of hot tap water at 98 degrees using the thermometer included
• Start the 2 minute timer (rubber sets in 2 minutes so be quick) and mix the materials together with the hot water in a mixing bowl (it will still be a little lumpy).
• Mix vigorously for 30 seconds and pour the material into the tube.
• Insert your fully ERECT penis into the tube until it is pressed against your body and your penis is at the end of the tube.
• Make sure the end of the penis is covered in material by rotating the tube if needed (BEFORE setting time)
• After 2 minutes remove your penis carefully from the mould and let it set for a couple of hours before moving onto to the next step.

Step 2 - Filling the Mould

• Open the bottles of liquid rubber and skin and pour into a clean paper cup and remove all liquid from the bottle with the stirrer.
• Stir the mixture for 2 minutes and fill the mould you created earlier to an inch below the top of the tube.
• Take a 4 inch square piece of cardboard and pierce a whole in the middle, push the vibrator through this until only the screwcap sticks out at one end. Insert vibrator into the centre of the rubber filled mould until the cardboard is flat against the rim of the tube.
• Let the rubber set for a full 24 hours - You should now how a perfect clone of your penis!

• Batteries: 2x AA size
• Size: 9 x 2 inches / 230mm x 50mm
• Material: Life-like realistic rubber

Batteries:	(+£1.89)
Sex Toys Cleaner 100ml:	(+£4.79)
Super Slik Lube 100ml:	(+£2.49)
Trojan Pleasure Condoms 3 Pack:	(+£3.99)